Skip to content

Change WiFi Location — K2 Plus

The K2 Plus connects to your local WiFi network during initial setup. If you move the printer or change your network, you can reconnect directly from the touchscreen.

Change WiFi from Touchscreen

  • On the touchscreen go to Settings → Network
  • Tap your current network to disconnect, or tap + to add a new network
  • Select your network from the list and enter the password
  • The printer reconnects and displays the new IP address

Find Your Printer's IP Address

After connecting, the IP address is shown in Settings → Network.

You can also find it from your router's DHCP client list — look for a device named K2Plus-XXXX where XXXX is the last 4 characters of your printer's MAC address.

Set a Static IP

For a stable IP that does not change between reboots, configure a DHCP reservation on your router (recommended). Assign a permanent IP to the printer's MAC address — this requires no changes on the printer itself and survives factory resets.

Reconnect After Factory Reset

After a factory reset the printer loses its WiFi credentials. Reconnect from the touchscreen:

Settings → Network → select your network → enter password

Root access must also be re-enabled after a factory reset. See Enable Root Access.